Description
- Lynxmotion SES-V2 Arduino Compatible IO Board for LSS (LSS-2IO)
- Arduino-compatible ATMega328P microprocessor
- Multiple serial communication modes
- On-Board RGB LED
- LSS mounting pattern
- Breakout of 6 Input / Output
- Enables RC control & capture of Analog sensors (2RC project)
The Lynxmotion SES-V2 Arduino Compatible IO Board for LSS (LSS-2IO) ("Lynxmotion Smart Servo To Input / Output") module was designed as a multi-purpose board intended to "bridge the gap" between a Lynxmotion Smart Servo (LSS) serial bus and regular 3-pin RC servos and 5V sensors. Since the LSS-2IO is effectively an Arduino-compatible microcontroller board, it can also be re-programmed using the standard Arduino IDE software to communicate with digital, analog or I2C sensors acting as a standard Arduino board. It can also be used as a USB-to-Serial Adapter to directly control a Lynxmotion Smart Servo via USB.
- 1x LSS-2IO Module
- 1x LSS 150 mm Serial Cable
- 1x Jumper for 2.54 mm Pins
- 3x 2-56 x 1/4 inch - Phillips Head Screw - Black
Websites
- Microcontroller: ATMega328P
- USB-to-Serial IC: CH340E ()
- Logic voltage: 5 V
- Analog voltage rail: 5 V
- Logic 5V maximum current: 200 mA
- Analog 5V rail maximum current: 1.2 A
- Number of analog pins: 3
- Number of digital IO pins: 3
- Input voltage via LSS connector: 6 - 12 V
- Maximum rated current through LSS connectors: 2 A
- Default baud rate in 2RC mode (with LSS-2IO Arduino program pre-loaded): 115200